Futaba 6EXAP 6-Channel PCM 35Mhz/ R136HP/ 4xS3003 [6EXAP_c7]

Price:

CAD$272.58

Brand:

Futaba

Model:

6EXAP_c7

Not Available

Please kindly input your name and email address, we will inform you once we have the restocking.

Or you may find similar product under the
R/C Models - System - Transmitter - Flight Transmitters category

Write a review

Description

QUALITIES:

Aileron, Elevator and Rudder twin cost switch - utilize this modification to ��flip�� between two aileron, elevator and rudder control throw settings. The tosses is generate however choose, but generally speaking, whenever switch is ��up�� the throws are greater (��high rate��) once the switch is ��down�� the throws are less (��low rate��). This switch additionally flips between exponential rates (if utilized).
Flap control dial/Channel 6 - This dial runs the servo installed on channel 6 towards receiver should your model has flaps this is actually the control always operate them.Aileron/elevator control stick -Mounting point for optional throat strap.
Trim levers (all) -Used for the fundamental or center host to every servo as labeled into the diagram.
Recharging jack - Port for recharging the transmitter batteries along with the included battery power charger.
On-off switch
INFORMATION INPUT lever - accustomed replace the values associated with different functions shown towards LCD display screen.
Liquid-crystal display (LCD) - shows development modes and values joined up with with.
MODE key - constantly scroll through and show the ten or eleven(PCM) various functions.
PICK key - constantly expose the values today's function.
Throttle-cut key - to work well with the throttle-cut function, lower the throttle stick totally, then drive the throttle-cut key to totally shut the carburetor and shut of motor.
Throttle/rudder control stick - runs the servos attached to channel 3 (throttle) and channel 4 (rudder) in the receiver.
Trainer switch - runs the trainer functions. For results as a trainer switch the transmitter should be associated with another transmitter via. a trainer cable (available individually).
Retractable landing gear switch/Channel 5 - Switch runs the servo linked to channel 5 inside receiver in the event your model has retractable landing gear this is actually the control constantly expand and retract the apparatus.
Antenna - Radiates signals on receiver. Never ever travel a model without completely expanding the antenna or maybe you could produce disruption to varied other modelers and decrease practical alert array of the transmitter. The antenna could be removed and changed with another whenever its unintentionally broken.

Hot Brands

Futaba 6EXAP 6-Channel PCM 35Mhz/ R136HP/ 4xS3003 [6EXAP_c7]